Our Standard Bench Shield and PMRS™

INSTALLATION INSTRUCTIONS For BG-Koo3/4

• PARTS LIST:
  1. Standard Bench Shield™
  2. Disposable standard lens
  3. Disposable magnifying lens
  4. 1” Right angle
  5. Vacuum filter bag (BG-K003)
  6. Vacuum recovery bag (BG-K003)
  7. 6” x 1” Plastic vacuum chase tube
  8. 15” x 1” Plastic vacuum chase tube
  9. Storage Holding bracket

  INSTALLATION INSTRUCTIONS

  Your new Standard BENCH SHIELD KIT and PMRS© are easy to install. You will need and the following:

  
  

  • Tape measure
  • Philips screwdriver
  • Hand saw
  • Drill
  • 1/8” drill bit    
  • 1 1/2” Hole saw
  1. Lay out the parts of the BENCH SHIELD + PMRS©
  2. Determine where your vacuum will be located.
  3. Remove your bench pin, tray, and drawer from your bench.
  4. Determine the location of the BENCH SHIELD Vacuum Chase by positioning the vacuum chase hole on the back, or the side of your bench. If the side of the bench will be used, there is an additional 6” vacuum chase and a right-angled vacuum chase included to allow for different configurations. If needed, cut vacuum chase to length with a hacksaw or even your jewelers’ saw.
  5. Gently insert the 12” vacuum chase pipe into the BENCH SHIELD bench bracket. Position the BENCH SHIELD bench bracket under your bench pin, then run the vacuum chase to the spot where it will go inside your bench and out the back or side, marking the hole.
  6. Use either a jigsaw or a hole saw bit to cut the 11/2 ” diameter vacuum chase hole.
  7. Install the BENCH SHIELD Bench Bracket (# BG-T03) directly under your bench pin using the 4 screws provided.
  8. Secure a snug fit of the vacuum chase to the BENCH SHIELD bench bracket. Run the vacuum chase through your 2” hole. Attach you vacuum hose to the vacuum.
  9. Attach the BENCH SHIELD Filter Bag  (BG-K003)over your vacuum filter.
  10. Line the bottom of the vacuum with the BENCH SHIELD Recovery Bag  (BG-K003).
  11. You are provided a standard and a magnifying lens. Try each by simply unscrewing the 4 screws and inserting the lens in the BENCH SHIELD *For best results use both together the BENCH SHIELD Magnification Lens behind the BENCH SHIELD Standard Lens, fresnel side toward the standard lens.
  12. Insert the BENCH SHIELD Face Shield Head into the BENCH SHIELD bench bracket. Plug your Standard Bench Shield + PMRS™ into the bench bracket.

  For best results use a removable bench pin and use the Bench Shield without your bench pin.

  Now You’re ready to start saving time, your health and money!

  Any questions? Need help?       Email us:   office@benchguru.biz

  Like us on FACEBOOK

  Follow us on twitter @BenchGuru

  MADE IN AMERICA

  www.benchguru.biz     (Tel. ) 414-488-2727